/* * QEMU Sparc32 DMA controller emulation * * Copyright (c) 2006 Fabrice Bellard * * Permission is hereby granted, free of charge, to any person obtaining a copy * of this software and associated documentation files (the "Software"), to deal * in the Software without restriction, including without limitation the rights * to use, copy, modify, merge, publish, distribute, sublicense, and/or sell * copies of the Software, and to permit persons to whom the Software is * furnished to do so, subject to the following conditions: * * The above copyright notice and this permission notice shall be included in * all copies or substantial portions of the Software. * * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR * IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, * FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL * THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER * LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, * OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN * THE SOFTWARE. */ #include "hw.h" #include "sparc32_dma.h" #include "sun4m.h" #include "sysbus.h" /* debug DMA */ //#define DEBUG_DMA /* * This is the DMA controller part of chip STP2000 (Master I/O), also * produced as NCR89C100. See * http://www.ibiblio.org/pub/historic-linux/early-ports/Sparc/NCR/NCR89C100.txt * and * http://www.ibiblio.org/pub/historic-linux/early-ports/Sparc/NCR/DMA2.txt */ #ifdef DEBUG_DMA #define DPRINTF(fmt, ...) \ do { printf("DMA: " fmt , ## __VA_ARGS__); } while (0) #else #define DPRINTF(fmt, ...) #endif #define DMA_REGS 4 #define DMA_SIZE (4 * sizeof(uint32_t)) /* We need the mask, because one instance of the device is not page aligned (ledma, start address 0x0010) */ #define DMA_MASK (DMA_SIZE - 1) #define DMA_VER 0xa0000000 #define DMA_INTR 1 #define DMA_INTREN 0x10 #define DMA_WRITE_MEM 0x100 #define DMA_LOADED 0x04000000 #define DMA_DRAIN_FIFO 0x40 #define DMA_RESET 0x80 typedef struct DMAState DMAState; struct DMAState { SysBusDevice busdev; uint32_t dmaregs[DMA_REGS]; qemu_irq irq; void *iommu; qemu_irq dev_reset; }; /* Note: on sparc, the lance 16 bit bus is swapped */ void ledma_memory_read(void *opaque, target_phys_addr_t addr, uint8_t *buf, int len, int do_bswap) { DMAState *s = opaque; int i; DPRINTF("DMA write, direction: %c, addr 0x%8.8x\n", s->dmaregs[0] & DMA_WRITE_MEM ? 'w': 'r', s->dmaregs[1]); addr |= s->dmaregs[3]; if (do_bswap) { sparc_iommu_memory_read(s->iommu, addr, buf, len); } else { addr &= ~1; len &= ~1; sparc_iommu_memory_read(s->iommu, addr, buf, len); for(i = 0; i < len; i += 2) { bswap16s((uint16_t *)(buf + i)); } } } void ledma_memory_write(void *opaque, target_phys_addr_t addr, uint8_t *buf, int len, int do_bswap) { DMAState *s = opaque; int l, i; uint16_t tmp_buf[32]; DPRINTF("DMA read, direction: %c, addr 0x%8.8x\n", s->dmaregs[0] & DMA_WRITE_MEM ? 'w': 'r', s->dmaregs[1]); addr |= s->dmaregs[3]; if (do_bswap) { sparc_iommu_memory_write(s->iommu, addr, buf, len); } else { addr &= ~1; len &= ~1; while (len > 0) { l = len; if (l > sizeof(tmp_buf)) l = sizeof(tmp_buf); for(i = 0; i < l; i += 2) { tmp_buf[i >> 1] = bswap16(*(uint16_t *)(buf + i)); } sparc_iommu_memory_write(s->iommu, addr, (uint8_t *)tmp_buf, l); len -= l; buf += l; addr += l; } } } static void dma_set_irq(void *opaque, int irq, int level) { DMAState *s = opaque; if (level) { DPRINTF("Raise IRQ\n"); s->dmaregs[0] |= DMA_INTR; qemu_irq_raise(s->irq); } else { s->dmaregs[0] &= ~DMA_INTR; DPRINTF("Lower IRQ\n"); qemu_irq_lower(s->irq); } } void espdma_memory_read(void *opaque, uint8_t *buf, int len) { DMAState *s = opaque; DPRINTF("DMA read, direction: %c, addr 0x%8.8x\n", s->dmaregs[0] & DMA_WRITE_MEM ? 'w': 'r', s->dmaregs[1]); sparc_iommu_memory_read(s->iommu, s->dmaregs[1], buf, len); s->dmaregs[0] |= DMA_INTR; s->dmaregs[1] += len; } void espdma_memory_write(void *opaque, uint8_t *buf, int len) { DMAState *s = opaque; DPRINTF("DMA write, direction: %c, addr 0x%8.8x\n", s->dmaregs[0] & DMA_WRITE_MEM ? 'w': 'r', s->dmaregs[1]); sparc_iommu_memory_write(s->iommu, s->dmaregs[1], buf, len); s->dmaregs[0] |= DMA_INTR; s->dmaregs[1] += len; } static uint32_t dma_mem_readl(void *opaque, target_phys_addr_t addr) { DMAState *s = opaque; uint32_t saddr; saddr = (addr & DMA_MASK) >> 2; DPRINTF("read dmareg " TARGET_FMT_plx ": 0x%8.8x\n", addr, s->dmaregs[saddr]); return s->dmaregs[saddr]; } static void dma_mem_writel(void *opaque, target_phys_addr_t addr, uint32_t val) { DMAState *s = opaque; uint32_t saddr; saddr = (addr & DMA_MASK) >> 2; DPRINTF("write dmareg " TARGET_FMT_plx ": 0x%8.8x -> 0x%8.8x\n", addr, s->dmaregs[saddr], val); switch (saddr) { case 0: if (!(val & DMA_INTREN)) { DPRINTF("Lower IRQ\n"); qemu_irq_lower(s->irq); } if (val & DMA_RESET) { qemu_irq_raise(s->dev_reset); qemu_irq_lower(s->dev_reset); } else if (val & DMA_DRAIN_FIFO) { val &= ~DMA_DRAIN_FIFO; } else if (val == 0) val = DMA_DRAIN_FIFO; val &= 0x0fffffff; val |= DMA_VER; break; case 1: s->dmaregs[0] |= DMA_LOADED; break; default: break; } s->dmaregs[saddr] = val; } static CPUReadMemoryFunc * const dma_mem_read[3] = { NULL, NULL, dma_mem_readl, }; static CPUWriteMemoryFunc * const dma_mem_write[3] = { NULL, NULL, dma_mem_writel, }; static void dma_reset(DeviceState *d) { DMAState *s = container_of(d, DMAState, busdev.qdev); memset(s->dmaregs, 0, DMA_SIZE); s->dmaregs[0] = DMA_VER; } static const VMStateDescription vmstate_dma = { .name ="sparc32_dma", .version_id = 2, .minimum_version_id = 2, .minimum_version_id_old = 2, .fields = (VMStateField []) { VMSTATE_UINT32_ARRAY(dmaregs, DMAState, DMA_REGS), VMSTATE_END_OF_LIST() } }; static int sparc32_dma_init1(SysBusDevice *dev) { DMAState *s = FROM_SYSBUS(DMAState, dev); int dma_io_memory; sysbus_init_irq(dev, &s->irq); dma_io_memory = cpu_register_io_memory(dma_mem_read, dma_mem_write, s); sysbus_init_mmio(dev, DMA_SIZE, dma_io_memory); qdev_init_gpio_in(&dev->qdev, dma_set_irq, 1); qdev_init_gpio_out(&dev->qdev, &s->dev_reset, 1); return 0; } static SysBusDeviceInfo sparc32_dma_info = { .init = sparc32_dma_init1, .qdev.name = "sparc32_dma", .qdev.size = sizeof(DMAState), .qdev.vmsd = &vmstate_dma, .qdev.reset = dma_reset, .qdev.props = (Property[]) { DEFINE_PROP_PTR("iommu_opaque", DMAState, iommu), DEFINE_PROP_END_OF_LIST(), } }; static void sparc32_dma_register_devices(void) { sysbus_register_withprop(&sparc32_dma_info); } device_init(sparc32_dma_register_devices)